Optionals
Pneumatics with micro electro valves
Pneumatics and valves with very small volumes and high speeds drive: it allows great accuracy and speed on small volume pieces under test.
Application of a mechanical regulator at very high precision: it can regulate pressure test with better accuracy and stability. Recommended for low pressures.
Pneumatic module of remote measurements
Based on Micro Electro Valves is a Pneumatic Module external to the measure equipment and aimed to minimize parasite volumes, increasing test sensibility and speed on small sizes of volume.
Internal card to interface the instrument to a Profinet network compatible with the most common industrial PLCs.
Internal Ethernet card to interface the equipment to an EtherCAT fieldbus controller
Bluetooth Low Energy communication interface
Bi-manual logic Start Input
It accepts Start cycle by two separate Start signals (instead of only one) adhering to the regulations for bi-manual command EN 574. ATTENTION: Unless different annotations contained in each instrument handbooks, this sequence means to make safer the instrument utilization for single use and it cannot in any case be intended as a safe element for other parts handling (ex: presses, control cycles, etc...) connected to them.
USB port of Host type for the connection of a key storage for test results and for the copy of test parameters from an instrument to another one.
High resolution measure
By the application of superior components and transducers , a metrologic resolution of the measure of 1.000.000 points is guaranteed.